Setting Up The User Information - Vatech PaX-i Insight Installation Manual

Setting up the User Information

9.5
Running EzDent-i as an Administrator
Right-click the EzDent-i icon and click Properties to open the properties dialog
1.
box.
PaX-i Plus / Insight (Model: PCH-30CS) Installation Manual
Go to the corresponding section for set-up instructions,
based on the viewer program (EzDent-i (SDK)) installed on
PC.
EzDent-i: Refer to section 9.5.1 when EzDent-i is installed.
The automatic interworking function is activated only when
using the Console program with automatic interworking
function and EzDent-i program. If it is not able to use the
automatic interworking function, or if it needs to set it
manually after the automatic interworking, follow the
procedure below.
Because of the different levels of authority between Console
Software and EzDent-i, the program may not run properly.
Configure the EzDent-i to run as an administrator before
running the program to avoid the problem.
9. Installing Software
107