Port; Server Configuration - Provision ISR IP Series User Manual

Page 39
IP CAMERA USER MANUAL
internet. After saving the username/password information set up IP address change
notification. Last, connect with Modem and the device will dial-up internet automatically.
Press the "Save" button to save the settings.
The next tab is "IP Change Notification Config": If you have used DHCP and you need to be
notified that the IP Address assigned to the camera was changed, enable it and set Email or
FTP for the notification process.

4.6.2 Port

1. Go to "Network" → "Port" to see the interface as shown below.
2. Input port number for IE access in the "HTTP Port" textbox.
3. Input the port number for audio & video transmission in the "Data Port" textbox.
4. Set the RTSP port for video/audio transmission over RTSP
5. Set the HTTPS port in case that you wish to use Secured HTTP connection.
4.6.3 Auto Report Server Configuration
Go to "Network"→ "Auto Report Server".
This section refers to "Auto Report Server". Enable it if required.
Auto report server will make the camera to report back to the defined Ossia VMS
authentication server using the port 2009.
Set the port (default port is 2009. It is advisable not to change it.) Set the server address