Provision ISR IP Series User Manual page 24

Page 19
4.3.1 PTZ Settings
Go to "PTZ"→ "PTZ settings"
4.3.1.1 PTZ Settings:
Auto PTZ Flip: set weather the camera
will perform auto flip when reaching
90° tilt angle.
OSD Language:
language of the Preset 95 OSD menu
OSD Auto Logout: Enable it if you wish
the preset 95 OSD menu to automatically close after the set period of time.
4.3.1.2 RS-485 (Applicable for Z6 only):
Set the RS-485 values for analog
controllers
PTZ ID: The analog ID of the camera
Protocol: The controlling Protocol you
wish to use
Baud-Rate: the desired controlling
baud-rate
*Please Note: All parameters must match exactly the setting of the analog controlling
device. Otherwise, the camera will not respond.
4.3.1.3 Others (OSD Password):
This allows you to set a password for accessing the preset 95 OSD Menu
Keep both fields empty if you don't require password.
4.3.2 Restore
Go to "PTZ"→ "Restore" allows you to restore some or all of the PTZ parameters.
"Reset" resets all the setting of the camera to factory default.
"Clear" clears all the presets, cruise and patterns saved on the camera.
4.3.3 Smart Tracking
Go to "PTZ"→ "Smart Tracking" allows you to modify the PTZ smart tracking feature.
Control Priority: Set the priority for controlling the camera (Tracking/Manual Priority). Note
that if "Tracking Priority" is set the user cannot control the camera under any circumstances.
Still time (Seconds): If a tracked target is motionless for the time specified above, the camera
will return to the home position.
IP CAMERA USER MANUAL
The preferred