General Fault - Provision ISR IP Series User Manual

Page 22
IP CAMERA USER MANUAL

4.4.2 General Fault

A problem with the network cable or with the SD card will produce a general fault. The alarms
can be configured as follows: SD Card Full, SD Card Error, IP Address Conflict, Network cable
disconnected.
Enter "Alarm Configuration" "General Faults" to see a screen as shown below. The default
→
tab is "SD Card Full":
Enable the alarm if required. This alarm will only be relevant if "Recycle Record" is not marked.
If "recycle record" is active, the SD card will never get full.
After enabling the alarm, choose the responses required from the camera in case the alarm
will be active. After the setting is complete, click "Save".
Next is the "SD Card Error" Tab. This alarm will be triggered if any fault will be developed with
the SD card. It can be a malfunction or removing the SD card from the camera.
To activate it, enable the alarm.