Cable Assembly From The Operator Control Panel To The Backplane Connector Board - IBM TS3310 Maintenance Information

2. Perform the following CRU procedures using the control module:
3. Perform one of the following procedures:
4. Remove the top, side, and bottom covers, as necessary, from the control
5. Perform the following FRU procedures using the control module:
6. Remove the cable assembly from the Operator Control Panel (OCP) to the
Figure 8-123. Cable assembly from the Operator Control Panel to the Backplane Connector Board
8-112
TS3310 Tape Library Maintenance Information
a. "Removing the Library Control Blade/ Compact Flash Assembly" on page
8-46
b. "Removing a Drive Sled" on page 8-43
c. "Power Supply (Primary and Redundant)" on page 8-52
v "Removing a 5U Library (Control Module) from a Rack" on page 8-4
v "Removing a Control Module from a Standalone or Rack-mounted Library
(14U or larger)" on page 8-5
module.
a. "Removing an I/O Station" on page 8-35
b. "Removing the I/O Station Lock Assembly" on page 8-36
c. "M2 Robot Assembly" on page 8-67
d. All library magazines. "Removing/Replacing a Storage Column" on page
8-96
e. "Removing a Front Gear Rack" on page 8-106
Backplane Connector Board (BCB).
a. Remove the cable retainers (see 1 in Figure 8-123).
Note: The cable retainers may be black rubber 'O' rings as shown, or white
plastic beaded cable ties. If they are the white cable ties, it will be
necessary to cut them off and replace them with new cable retainers
included in the new FRU kit.
b. Remove the 2 screws from under the cable guide (see 2 in Figure 8-123)
near the I/O Station lock assembly.
1 2
c. Unplug cable connectors J9 (see 2 in Figure 8-124 on page 8-113), J16 (see
3 in Figure 8-124 on page 8-113), and J15 (see 4 in Figure 8-124 on page
8-113) from the BCB.