IBM TS3310 Maintenance Information page 78

|
|
|
|
|
|
|
|
|
|
Figure 4-2. Operator Panel Login screen for firmware versions 585G and later
|
|
|
|
|
|
|
|
|
|
|
|
|
|
4-2
TS3310 Tape Library Maintenance Information
using local authentication (the login and password are stored on the library)
or LDAP authentication (the login and password are stored on a server, and
the user must specify the LDAP domain name). If LDAP access is disabled,
the Local and Remote authentication options will not appear on the login
screen. Kerberos requires LDAP information, but LDAP users are not
required to use Kerberos.
For initial login, the administrator should use the following:
v User name: admin
v Password: secure
To fill in the User name, lightly touch the blank field to display the alphabetic and
numeric touch pads then, use the touch keys to spell out the user ID and touch
OK. Similarly, enter the password and touch OK.
After initial login change the Administrator password. To change the password,
perform the following steps:
v For firmware versions prior to 585G, the LDAP authentication choice is
presented on the Operator Panel as Remote authentication. From the Operator
Panel, select Setup → User Mgmt → Modify User.
v For firmware versions 585G and later, change the Administrator password. From
the Operator Panel, select Setup → User Mgmt → Modify User.