Four Screws On Front Of Door And Plastic Cable Guide; Interface - IBM TS3310 Maintenance Information

1 2
4
3
Figure 8-126. Four screws on front of door and plastic cable guide
h. Carefully remove the cable assembly from the enclosure.
7. Remove the cable assemblies between the Power Supplies, the Drive Sled
Interface Board (DSIB), and the Backplane Connector Board (BCB) by following
these procedures:
a. Remove the "Cable Spool Assembly" on page 8-100.
b. Remove the hex stand-off (see 1 in Figure 8-127 on page 8-116) from
behind the Cable Spool Assembly. This requires a 5 mm (3/16-inch) wrench.
8-115
Chapter 8. Add, Check, Adjust, Remove, and Replace Procedures