Replacing A Storage Column - IBM TS3310 Maintenance Information

3
4
Figure 8-112. Replacing a Storage Column
3. Ensure correct orientation by inserting:
4. Push the column towards the rear of the library ( 5 in Figure 8-112) to engage
5. Repeat this procedure for each column.
6. For a 5U library, perform "Replacing the M2 Robot Assembly" on page 8-69.
5
1
Tab 1 on a storage column
2
Tab 2 on a storage column
a. Tab 1 (in Figure 8-112) into slot 3 (in Figure 8-112)
b. Tab 2 (in Figure 8-112) into slot 4 (in Figure 8-112)
the locking tabs on the back of the column.
1
2
3
Slot 1 in the library chassis wall in a storage
column position
4
Slot 2 in the library chassis wall in a storage
column position
Chapter 8. Add, Check, Adjust, Remove, and Replace Procedures
8-99