Removing A Tape Cartridge; Using Ultrium Media; Inserting A Cartridge Into The Drive - IBM TS3310 Maintenance Information

3. Grasp the cartridge so that the write-protect switch faces you (see 1 in
4. Slide the cartridge into the tape load compartment.
Figure D-2. Inserting a cartridge into the drive

Removing a Tape Cartridge

To remove a tape cartridge:
1. Ensure that the drive is powered ON.
2. Press the Unload Button. The drive rewinds the tape and partially ejects the
3. After the cartridge partially ejects, grasp the cartridge and remove it.
Whenever you unload a tape cartridge, the drive writes any pertinent information
to the cartridge memory.

Using Ultrium Media

To ensure that your IBM Ultrium Tape Drive conforms to IBM's specifications for
reliability, use only IBM LTO Ultrium tape cartridges. You may use other
LTO-certified data cartridges, but they may not meet the standards of reliability
that are established by IBM. The IBM LTO Ultrium Data Cartridge can not be used
in other IBM non-LTO Ultrium tape products.
Figure D-2).
Note:
a. If the cartridge is already in an ejected position and you want to
reinsert it, remove the cartridge then insert it again.
b. If the cartridge is already loaded and you cycle the power (turn it
OFF, then ON), the tape will reload.
cartridge. The Status Light flashes green while the tape rewinds, then goes out
before the cartridge partially ejects.
Appendix D. Using Ultrium Drives
D-5