Rear Panel Components; Drive Sled; Drive Sled (Detail); Tape Drive - IBM TS3310 Maintenance Information

Rear Panel Components

The library has the following rear panel customer replaceable units (CRUs):
v Drive Sled
v Library Control Blade (LCB)
v Library Power Supply

Drive Sled

Tape drives mounted in sleds are installed into tape drive slots in the rear of the
library.
Removing a Drive Sled
Important: If removing more than one drive sled at a time, record the locations of
1. Vary all drives offline from the host.
Figure 8-46. Drive sled (detail)
2. Disconnect the drive cable and place it on a flat surface in a secure location to
each drive before they are removed. Ensure that the drives are
reinstalled in the correct location.
v From the Operator Panel, select Operations → Change Drive Mode.
v From the Web User Interface, select Manage Drives → State (Online/Offline)
.
1
avoid damaging the cable.
Chapter 8. Add, Check, Adjust, Remove, and Replace Procedures
2
4
5
3
8-43