Library Control Blade (Lcb) - IBM TS3310 Maintenance Information

Figure 8-52. Library Control Blade (LCB)
3. Reconnect the Ethernet cable ( 2 in Figure 8-52) by pinching the tab and
4. Power ON the library and wait for it to initialize. This may take from 2 to 10
5. Perform "Returning a Library or Library Module to Normal Operations after
Upgrading the Compact Flash Card Firmware
If the Compact Flash Card is new and has never been initialized, it contains a
minimal level of library firmware which allows the library to boot up and display
an Upgrade Notification message. In order to use the library, you must upgrade to
the latest level of library firmware. Use the following steps to upgrade firmware
the first time you use a new Compact Flash Card.
2
1
3
4
1
Module communication
terminator
2
Ethernet cable (customer
supplied)
3
Latches
pushing the connector into the LCB.
Note: Six slots reside below the Ethernet cable. The four topmost slots are
reserved for future use. The two bottommost slots are designated as
Ethernet ( 5 in Figure 8-52) and serial ( 6 in Figure 8-52) ports, and are
reserved for use by IBM Service Personnel.
minutes, depending on the level of firmware on the Library. If the Compact
Flash Card is new and has never been initialized, see "Upgrading the Compact
Flash Card Firmware."
Repairs" on page 8-4.
4
Module-to-module communication cable
5
Ethernet port (for IBM service personnel use)
6
Serial port (for IBM service personnel use)
Chapter 8. Add, Check, Adjust, Remove, and Replace Procedures
5
6
8-51