IBM TS3310 Maintenance Information page 288

Replacement of either the LCB or the CF requires the removal of the LCB/CF
Assembly from the library.
Important: Before removing the LCB/CF Assembly from the library, ensure that
you have performed "Saving/Restoring System Configuration" on page 7-12 and
that the saved file is available. If the CF card is replaced, you will need this file to
reconfigure the library.
Following is a partial list of the configuration items that are saved:
v Current library firmware
v Network settings:
v Feature Code licenses keys
v Logical library configuration
v Cartridge slot assignments
v Cleaning slot configuration
v I/O Station configuration
v Drive IDs:
v Encryption method selections
v Administrator and user account information
Removing the Library Control Blade/ Compact Flash Assembly
Important: Before removing the LCB/CF Assembly from the library, ensure that
Important: When handling the LCB, you must wear an ESD anti-static wrist
1. Perform "Preparing a Library or Library Module for Repairs" on page 8-4.
2. On the LCB (Figure 8-49 on page 8-47), disconnect the Ethernet cable ( 2 in
8-46
TS3310 Tape Library Maintenance Information
– IP Address
– Subnet Mask & Gateway addresses
– SCSI ID
– Fibre Loop ID
– SAS ID
you have the current library configuration data available. If the CF
card is replaced, you will need the following information to reconfigure
the libary:
v IP address
v Subnet mask address
v Gateway address
v Library firmware level
v License keys, if applicable
See "Saving/Restoring System Configuration" on page 7-12. Also, see
Appendix E: "Library Configuration Form" in the TS3310 Setup and
Operator Guide.
strap, or touch the library frame to discharge any static electricity in
your body. Do not handle the LCB without taking appropriate ESD
precautions.
Figure 8-49 on page 8-47) by pinching the tab to disengage the cable, and then
pull the connector out of the LCB.