Check Cooling System And Refill As Required; Check Level Of Window Washer Liquid - Doosan DX700LC Operation And Maintenance Manual

Check Cooling System and Refill As
Required
Allow the engine to cool before releasing the radiator cap.
Make sure to loosen the cap slowly to release any
remaining pressure.
Radiator cleaning is performed while the engine is running.
Take extreme caution when working on or near a running
engine. Make sure to lock out and tag the controls notifying
personnel that service work is being performed.
Do not remove the radiator cap unless it is required.
Observe the coolant level in the coolant recovery tank.
NOTE: Do not mix ethylene glycol and propylene glycol
antifreeze together. If the two are mixed, the
protection level will be reduced to the level of the
ethylene glycol.
1. When the engine is cold, remove the radiator cap and
check the coolant level inside the engine room. Do not rely
on the level of coolant in the coolant recovery tank. Refill
radiator as required. Refer to coolant concentration table.
(See page 4-83) (2 Reserve tank)
2. Check to make sure that the coolant transfer line from the
coolant recovery tank to the radiator is free and clear of
obstructions, or not pinched.
3. Observe the level of coolant in the coolant recovery tank.
The normal cold engine fluid level should be between
"FULL" and "LOW" marks on tank.
4. If the coolant is below the "LOW" mark, add coolant to this
tank.

Check Level of Window Washer Liquid

1. Open left front access door and check fluid level in
windshield washer tank.
2. Open fill cap and add fluid.
NOTE: Use a washer liquid that is rated for all seasons.
This will prevent freezing during cold weather
operation.
Inspection, Maintenance and Adjustment
WARNING
Figure 29
Figure 30
FG016103
FG016104
OP001123
4-21