Doosan DX700LC Operation And Maintenance Manual page 177

To activate breaker
1. Set breaker selector switch to "II" (BREAKER) position.
2. Press lower button on top of right-hand work lever
(joystick) to activate hydraulic breaker.
3. Release lower button on top of right-hand work lever
(joystick) to deactivate hydraulic breaker.
Relief Valve Adjustment
1. Cap pipe on arm end, using a cap capable of handling 350
2
kg/cm under the condition of disconnecting hose to
hydraulic breaker.
2. Adjust pump pressure using activating the breaker, and
watching the pressure displayed on the instrument panel.
Press the display selector button to show digital pressure
reading. (A separate pressure gauge is not required.)
3. Adjust the relief valve pressure by turning the adjustment
screw of breaker relief valve. The relief valve is installed on
the left side of the upper structure behind the boom. (Do
not use the overload relief valve on the lower part of control
valve for the breaker relief valve.)
If the relief valve pressure is adjusted while the
hydraulic breaker is connected, there is possibility
that a high-pressure spike or setting could break a
hose or pipe. Personal injury or death could result
from a hydraulic hose or pipe failure.
Operation
WARNING
I
O
I I
Figure 79 RIGHT-HAND WORK LEVER
(JOYSTICK)
Figure 80
FG000117
FG015792
OP001122
3-35