Doosan DX700LC Operation And Maintenance Manual page 84

Table of Contents

Advertisement

9. Breaker / Boost / Shear Selector
Switch
This switch is used to either select the breaker, power
boost, or shear.
O.
In this position, a hydraulic pressure rise will be
activated when pressing the button on the right-hand
work lever (joystick).
I.
In this position, shear is activated.
II.
In this position, breaker is activated.
Before using any attachment in a work application, be
sure to check its functional control. Make sure that the
desired movement or action is being activated by the
control. e.g. opening/closing, CW/CCW, crowd/dump, etc.
10. Cabin Work Light Switch (Optional)
This switch is used to control the cabin work lights, if unit is
equipped with them.
O.
In this position, all cabin work lights are turned "OFF".
I.
In this position, the front cabin work lights on the front
top of cabin will turn "ON".
II.
In this position, the front cabin work lights on the front
top of cabin and rear cabin work lights on rear top of
cabin will turn "ON".
11. Warning Light Switch (Optional)
If unit is equipped with a warning light, push this switch to
activate it.
O.
In this position, the warning light is turned "OFF".
I.
In this position, the warning light turns "ON" and will
start flashing.
Operating Controls
2-12
WARNING
I
O
II
Figure 16
O
I
II
Figure 17
O
I
Figure 18
FG000025
FG000026
FG000027
OP001121

Advertisement

Table of Contents
loading

Table of Contents