Doosan DX700LC Operation And Maintenance Manual page 165

Change Machine Control Pattern by Select
Valve (If Equipped)
Check surrounding area before swinging. When operating a
lever while in auto idle, do it carefully, because the engine
speed will increase rapidly.
NOTE:
When starting work, move work levers (joysticks)
slowly and check movement of swing and front
attachment.
The machine control pattern can easily be changed to the ISO
standard or to the standard backhoe loader hydraulic system
(BHL) by changing the position of the select valve (if equipped).
Use the following procedure to change the position of the select
valve.
The select valve is located in the rear of the cabin.
1. Rotating spool to the ISO position or to the BHL position.
(Figure 49)
Operation
WARNING
1
3
4 7
2
Figure 48
<ISO PATTERN>
<BHL PATTERN>
Figure 49
5
8
6
FG000381
FG004954
OP001122
3-23