Doosan DX700LC Operation And Maintenance Manual page 89

22. Rotating Buttons
For a machine equipped with an attachment that rotates,
press the upper two buttons on the top of the left-hand
work lever (joystick) to rotate the attachment clockwise or
counterclockwise. Left button is for counterclockwise and
the right one is for clockwise.
Before using any attachment in a work application, be
sure to check its functional control. Make sure that the
desired movement or action is being activated by the
control. e.g. opening/closing, CW/CCW, crowd/dump, etc.
23. Booster Button (Right-hand Work
Lever)
Press the lower button on the top of the right-hand work
lever (joystick) to boost the hydraulic pressure. Refer to the
"Boost Mode" on page 3-21.
NOTE:
This button works with the breaker/boost/shear
selector switch. See "9. Breaker / Boost / Shear
Selector Switch" on page 2-12.
24. Shear Buttons
For a machine equipped with shear, press the two upper
buttons on the top of the right-hand work lever (joystick) to
open or close the shear. Left button is for closing (crowd),
right button is for opening (Dump).
NOTE: These buttons work with the breaker/boost/
shear selector switch. See "9. Breaker / Boost /
Shear Selector Switch" on page 2-12.
Before using any attachment in a work application, be
sure to check its functional control. Make sure that the
desired movement or action is being activated by the
control. e.g. opening/closing, CW/CCW, crowd/dump, etc.
Operating Controls
WARNING
WARNING
Figure 32
Figure 33
Figure 34
FG000382
FG000036
FG000383
OP001121
2-17