Doosan DX700LC Operation And Maintenance Manual page 81

3. Quick Clamp Switch (Optional)
Clamp releasing for dispensable attachment is controlled.
O. In this position
attachment is secured to the arm.
I. In this position
The attachment is released from the arm.
NOTE:
To move the switch, pull up on the toggle
and then move it into the "UNLOCKED"
position.
When the attachment is still connected to the machine,
while the switch is "I" (
machine or the attachment might fall to the ground. It
would cause personnel injuries.
4. Auxiliary Mode Switch
When the control system is out of order, the pump system
can be controlled manually.
O. In this position, the manual pump control is "OFF".
I. In this position, the manual pump control is "ON".
Be sure to turn pump control to the "O" (OFF) position,
after the control system is operating properly.
5. Engine Emergency Stop Switch
If the engine does not shut down when using the starter
switch, it can be stopped by moving the engine emergency
stop switch to the "I" (EMERGENCY STOP) position.
O. In this position, the engine emergency stop system is
"OFF".
I. In this position, "EMERGENCY STOP" is selected.
The engine will shut down.
NOTE: 1. Press the switch "I" untill the engine stops.
2. When released, the switch will return to its
original position "O" (OFF) position.
Operating Controls
, the quick clamp is "LOCKED". The
, the quick clamp is "UNLOCKED".
WARNING
) position, do not operate the
CAUTION
I
Figure 6
O
I
Figure 7
O I
Figure 8
O
FG001342
FG001343
FG001344
OP001121
2-9