Doosan DX700LC Operation And Maintenance Manual page 106

3. Auto Idle Selector Button
When the auto idle system is activated, the engine will
automatically reduce speed to "IDLE" approximately four
seconds after all of the control levers are in the neutral
position. This system is designed to reduce fuel
consumption and noise.
When the auto idle selector button is pushed to the "ON"
position, an indicator light above it turns "ON".
When the auto idle selector button is pushed again, it is
turned "OFF" and the engine speed will return to the
setting of the engine speed dial and will remain at this
speed despite control lever position, until the engine speed
dial is moved.
4. Flow Control Button
When the button is pushed, you can control the hydraulic
oil flow rate.
The flow control button is used to set the flow rate of pump
to match the installed tool/attachment for optimal
performance, without damaging it.
NOTE: For further details, see "Flow Control" on
page 2-44.
Operating Controls
2-34
2
Figure 72
7
Figure 73
FG013711
FG013896
OP001121