Doosan DX700LC Operation And Maintenance Manual page 157

Travel Control Lever Operation
1. To travel straight (Figure 27), push both travel control
levers/pedals fully forward or backwards. The farther the
levers/pedals are pressed, the faster the travel speed.
NOTE:
"X" is the sprocket end of the track.
OPTION: Straight Travel Pedal (Figure 27, dotted line
view) - To travel straight, push travel control
pedal forward or backward without using travel
control levers. The farther the pedal is pressed,
the faster the travel speed.
2. Pivot turns (Figure 28) are made by rotating only one track
forward or backward. The machine will pivot on the
nonmoving track.
NOTE: "X" is the sprocket end of the track.
3. Spin turns (Figure 29) are made by rotating one track
forward and one track backward. The machine will spin
around its center point, thus counterrotating.
NOTE: "X" is the sprocket end of the track.
4. Stopping travel (Figure 30) - Returning travel levers to
"NEUTRAL" position will automatically apply brakes and
stop excavator.
NOTE:
"X" is the sprocket end of the track.
OPTION: Straight Travel Pedal (Figure 30, dotted line
view) - Stop travel by letting travel pedal return
to "NEUTRAL" position. This will automatically
apply brakes and stop excavator.
Operation
"X"
Figure 27
"X"
Figure 28
"X"
Figure 29
"X"
Figure 30
FG016194
FG000304
FG000305
FG016195
OP001122
3-15