Doosan DX700LC Operation And Maintenance Manual page 87

16. Power Socket for 12 Volt
This is a power socket for only 12V DC devices.
This socket can be used for charging a cellular phone or
powering a small 12V DC electrical device.
Open the cap when using it.
NOTE: This socket is designed for small electrical
capacity devices. Do not use this socket for
large electrical capacity devices. Thus, damage
can be avoided.
17. Travel/Swing Alarm Switch (Optional)
If unit is equipped with a travel/swing alarm buzzer, push
this switch to active it, whenever swinging or traveling.
O. In this position, the travel/swing alarm system is
turned "OFF".
I. In this position, the travel alarm will only sound, when
the machine is moving.
II. In this position, the travel/swing alarm will sound
while swinging and traveling, if equipped with a swing
alarm device.
NOTE:
If machine is only equipped with a travel
alarm device, the alarm will not sound
when swinging although the switch is in
the "II" position.
18. Overload Warning Switch (Optional)
If unit is equipped with an overload warning device, push
this switch to activate it.
O. In this position, the overload warning device is turned
"OFF".
I. In this position, when a load is lifted that reaches the
machine safe lifting limit, a warning light on the
instrument panel will turn "ON" and a warning buzzer
will sound.
To prevent injury, do not exceed the rated load
capacity of the machine. If the machine is not on level
ground, load capacities will vary. There may be local
government regulations about the use of excavators
for lifting objects.
Please observe these regulations.
Operating Controls
WARNING
12 V
Figure 26
O
I
II
Figure 27
O
I
Figure 28
HAAE1990
FG000031
FG000032
OP001121
2-15