Doosan DX700LC Operation And Maintenance Manual page 28

If the machine catches fire, it may lead to serious personal injury
or death. If a fire occurs during operation, escape from the
machine as follows;
• Turn the starter switch to the "O" (OFF) position and
shut down engine.
• If there is time, use the fire extinguisher to extinguish
as much of the fire as possible.
• Use the handrails and steps to escape from the
machine.
The above is the basic method for escaping from the machine,
but changing the method may be necessary according to the
conditions, so carry out practice drills at the work site.
Protection from Falling or Flying Objects
On work sites where there is danger that falling objects or flying
objects may hit the operator's cabin select a guard to match the
operating conditions to protect the operator.
Working in mines, tunnels, deep pits or on loose or wet surfaces
could produce danger of falling rock or hazardous flying objects.
Additional protection for the operator's cabin could be required in
the form of a FOPS (Falling Object Protective Structure) or
window guards.
Never attempt to alter or modify any type of protective structure
reinforcement system, by drilling holes, welding, remounting or
relocating fasteners. Any serious impact or damage to the
system requires a
Reinstallation, recertification and/or replacement of the system
may be necessary.
Contact your DOOSAN distributor for available safety guards
and/or recommendations if there is any danger of getting hit by
objects that could strike the operator's cabin. Make sure that all
other work site crew members are kept well away from the
excavator and safe from possible hazards.
For breaker operation, install a front guard and apply a
laminated coating sheet to the front glass. Contact your
DOOSAN distributor for recommendations.
When carrying out demolition or cutting operation, install a front
guard and top guard, and apply a laminated coating sheet to the
front glass.
When working in mines or quarries where there is danger of
falling rock, install FOPS (Falling Objects Protective Structure)
and apply a laminated coating sheet to the front glass.
If any glass on the machine is broken, replace it with new glass
immediately.
Safety
1-22
complete integrity
Figure 10
reevaluation.
Figure 11
HAOA110L
HAOA100L
OP001120