Doosan DX700LC Operation And Maintenance Manual page 286

Table of Contents

Advertisement

2.
Turn superstructure so it is perpendicular to side frame to
be retracted. Raise side frame to approximately a 15°
angle from ground using a jack. Side frame should slide by
its own weight and hit against stop.
NOTE:
If side frame does not slide in this condition,
allow side frame that is not contacting ground to
move back and forth slowly. See Figure 158.
The arm must be set at a 90 – 110° angle. Never set it
at an angle less than 90°
3.
After side frame (1, Figure 159) has slid into place, lower
superstructure to ground. Install five spacers, harden
washers and bolts (2).
NOTE:
Tighten bolts to 288 kg•m (2,083 ft lb).
NOTE:
Repeat procedure at other center frame
support.
4.
After bolts for one side frame are fastened, repeat Steps 1
thru 3 for other side frame.
5.
Store remaining bolts, spacers and washers with machine.
Frame Extension
1.
Remove five bolts, harden washers and spacers (1, Figure
160) from side frame (2) to be extended.
NOTE:
Do not loosen two bolts (3, Figure 160) on guide
(4).
NOTE:
Repeat procedure at other center frame support
(5, Figure 160).
Reference
Number
1
2
3
4
5
Transportation
5-4
CAUTION
Description
Bolt
Side Frame
Bolt
Guide
Center Frame Support
90 ~ 110
15
Figure 158
Figure 159
2
5
1
4
Figure 160
FG016363
1
2
FG016364
3
FG016365
OP001124

Advertisement

Table of Contents
loading

Table of Contents