Replacing The Battery - 2gig Technologies EDGE Installation Manual

Replacing the Battery

Follow the steps below to replace a battery in the 2GIG EDGE Panel:
1 . Remove the four screws that secure the back panel, and then
carefully remove the back cover from the panel.
2 . Carefully detach the power cable from the battery to be
replaced.
3 . Take hold of the battery, and carefully detach it from the panel.
Note: You may need to apply a reasonable amount of force to
separate the battery from the adhesive that holds it in place.
4 . Peel off the adhesive strip from the back of the new battery.
Adhesive Strip
21
Detach
Remove
Battery
Copyright © 2022 Nortek Security & Control LLC