Panel Programming - Keypads - 2gig Technologies EDGE Installation Manual

Security & smart home system

Hide thumbs Also See for EDGE:

Table of Contents

– K

anel

rogramming

eyPads

You can program up to eight (8) wireless keypads per system. To get started, navigate to the Installer Toolbox. Then, tap Keypads. This reveals

the Keypads screen.

NOTE: The 2GIG Edge panel and Remote Keypads must be

connected the same WiFi network, or the Remote Keypads must

be connected to the access point of the 2GIG EDGE Panel before

starting keypad programming. See Network Settings, page 38.

Keypad (#)

1 . Swipe up to move through the list of keypads.

2 . Tap to select one of the available keypads, then tap Edit Keypad. Make sure the

Keypad Used setting is highlighted.

3 . Under Keypad Used, choose Enabled or Disabled.

4 . Tap  to move to the next option.

5 . Tap PAIR KEYPAD. The panel will listen for a Keypad to pair.

6 . The panel will prompt to enter a code on the secondary panel.

7 . On the secondary panel, enter the pairing code.

Table of Contents