2gig Technologies EDGE Installation Manual page 32

Glass Break
To program the built-in Glass Break sensor, adjust the following
settings .
Sensor
1 . Tap Glass Break.
2 . Choose Enabled or Disabled.
3 . Tap  to move to the next option.
Voice Descriptor
1 . Highlight Voice Descriptor.
2 . Tap Edit Voice Descriptor to reveal the keypad.
3 . Use the keypad to enter the first few letters of the desired word.
4 . Tap the matching word above the keypad.
5 . Repeat the steps above to enter a phrase.
6 . Tap Done.
7 . Review the voice descriptor.
8 . Tap  to move to the next option.
Sensor Chime
1 . Highlight Sensor Chime.
2 . Choose Enabled or Disabled.
3 . Tap  to move to the next option.
Smart Areas Assignment
1 . Highlight Smart Areas Assignment.
2 . Choose a Smart Area (Partition) for the zone.
3 . Tap  to move to the next option.
Transmission Delay
1 . Highlight Transmission Delay.
2 . Choose Enabled or Disabled.
3 . Tap  to move to the next option.
Installation Guide for the 2GIG EDGE Security Panel
32