Connect Power (Barrel Connector); Connect The Backup Battery; Warning - 2gig Technologies EDGE Installation Manual

Connect Power (Barrel Connector)

An alternate method for connecting the AC power supply for the 2GIG EDGE Panel is to use the optional barrel connector (3.5mm).
To connect the power supply's barrel connector to the 2GIG EDGE Panel:
1 . Locate a wall outlet for the plug-in power supply. Do NOT connect the power supply to the outlet at this time.
IMPORTANT: When selecting a wall outlet, never connect the plug-in power supply to a switch-controlled outlet.
2 . Route the power wire from the plug-in power supply through the wiring cutout on the backplate of the 2GIG EDGE Panel.
3 . Plug the barrel connector into the DC power adapter barrel jack on the back of the 2GIG EDGE Panel.
WARNING!! Do NOT plug the power supply into the outlet at this time. Always complete all system wiring and then secure the backplate
to the 2GIG EDGE Panel before connecting its power supply to the outlet.
4 . After connecting or wiring the DC power supply on the panel, connect the backup battery (see below).

Connect the Backup Battery

5 . Ensure the backup battery is properly seated in the chassis. The battery's label should be facing up and the battery's connector wire
should be on the left with the wire running in the empty space between the battery compartment.
6 . Insert the wired battery pin into the PCB battery
connector.
7 . Plug-in the power supply to an outlet.
2GIG EDGE Panel—Backup Battery Connector

WARNING

»
Batteries must not be misused.
»
Lithium batteries have a cycle life, so please replace the old battery when it reaches it's service life.
»
While replacing the battery pack, it's important to handle with care. Do not drop or damage the battery. Follow replacement
instructions, and transport the old battery pack in a special battery fireproof bag. Consult local regulations to dispose old batteries.
»
Must keep battery pack away from children.
»
Panel will boot with only the battery connected AC power is not required to boot). Battery should be disconnected before shipping.
Installation Guide for the 2GIG EDGE Security Panel
20
Barrel
Connector
Battery Power Terminal