Panel Programming - Keyfobs - 2gig Technologies EDGE Installation Manual

Security & smart home system
Hide thumbs Also See for EDGE:
Table of Contents

Advertisement

Sensor Reports
1 . Highlight Sensor Reports.
2 . Choose Enabled or Disabled.
3 . Tap  to move to the next option.
P
P
– K
anel
rogramming
eyfoBs
Program up to 32 keyfobs per system. To begin, navigate to the Installer Toolbox, then tap Panel Programming > Keyfobs.
Select a Keyfob
1 . Swipe up to move through the list of keyfobs.
2 . Tap to select one of the available keyfobs.
3 . Tap Edit Keyfob.
1 . Highlight Fob Active.
2 . Under Fob Used, choose Enabled or Disabled.
3 . Tap  to move to the next option.
Select Equipment Code
1 . Highlight Equipment Code.
2 . Tap
to expand the list.
3 . Tap to select the desired equipment code from the list.
4 . Tap  to move to the next option.
Serial Number
1 . Highlight Serial Number.
2 . Tap Learn to enter Learning Mode.
3 . The 7-digit TX-ID listed on the product is detected.
4 . Press any button on the keyfob for three 3 – 5 seconds. The Sensor
Received message appears if successful.
TIP: Along with Learning Mode, you also have the option to
manually enter the 7-digit TX ID using the keypad.
5 . Verify the on-screen serial number matches the keyfob's 7-digit TX ID,
then tap Accept.
6 . Tap  to move to the next option.
Edit Voice Descriptor
Create a voice descriptor for the keyfob using the words in the
system's vocabulary.
1 . Highlight Voice Descriptor.
2 . Tap Edit Voice Descriptor to view the keypad.
3 . Enter the first few letters of the desired word.
4 . Tap the matching vocabulary word above the touchscreen keypad to
select it.
5 . Repeat the steps to enter phrases, then tap Done.
6 . Review the voice descriptor.
7 . Tap  to move to the next option.
33
Copyright © 2022 Nortek Security & Control LLC

Advertisement

Table of Contents
loading

Table of Contents