2gig Technologies EDGE Installation Manual page 29

If you selected a Sensor Type other than those listed above, skip this step.
1 . Highlight Sensor Equipment Type.
2 . Choose Contact, Emergency or Motion. Available options vary, depending on the selected Sensor Type.
3 . Tap  to move to the next option.
Enter TXID
1 . Tap TXID.
2 . Tap Learn to enter Learning Mode. This panel listens for the 7-digit TX
ID transmission from the sensor or peripheral.
TIP: Along with Learning Mode, you also have the option to
manually enter the 7-digit TX ID using the keypad.
3 . Trigger the sensor or peripheral (see the product's Installation
Instructions). When the 7-digit TX ID is received, Sensor Received
appears.
4 . Verify that the 7-digit TX ID on product and touchscreen match, then tap
Accept.
5 . Tap  to move to the next option.
Sensor Loop
1 . Highlight Sensor Loop.
2 . Choose Loop 1, Loop 2, or Loop 3.
NOTE: To determine the appropriate loop number, see the
Installation Instructions included with the sensor or peripheral.
3 . Tap  to move to the next option.
Voice Descriptor
Create a voice descriptor for the sensor or peripheral.
1 . Highlight Voice Descriptor.
2 . Tap Edit Voice Descriptor to reveal the keypad.
3 . Enter the first few letters of the desired word.
4 . Tap the matching word.
5 . Repeat the steps above to enter the desired phrase.
6 . Tap Done.
7 . Review the voice descriptor.
8 . Tap  to move to the next option.
Sensor Chime
1 . Highlight Sensor Chime.
2 . Choose the desired chime from the list. The default setting is Disabled.
Smart Areas Assignment
1 . Highlight Smart Areas Assignment.
2 . Under Smart Areas Assignment, choose a Smart Area (Partition) for the
zone.
3 . Tap  to move to the next option.
Transmission Delay
1 . Highlight Transmission Delay.
2 . Select Enabled or Disabled.
3 . Tap  to move to the next option.
29
Copyright © 2022 Nortek Security & Control LLC