System Test - 2gig Technologies EDGE Installation Manual

Security & smart home system

Hide thumbs Also See for EDGE:

Table of Contents

ystem

est

NOTE: The Panel Test and Network Test were not evaluated to ANSI SIA CP-01:

2010, Initiation of Test and Termination Test

Sensor Tests

After installing the system, sensors, and peripherals, perform a walk test to ensure

proper console operations and to test wireless reception and signal strength.

¾ Tap Sensors Tests, then walk to and trigger each sensor.

Panel Testing

Tap each button and respond Yes or No to each question. If any of the tests fail,

please contact your dealer for assistance.

Disable Sounder

Press YES to disable the Sounder. The panel will beep. The siren will be silent for 30

minutes or until it is re-enabled manually.

Cell Radio Test/Status

At the Radio Status screen, tap Test Cell Radio. Status for

Number

Subscriber ID

Registration Status

displayed.

Network Test

Tap this option to test LAN, Internet and Backend network connection status.

NOTE: The system is to be tested upon completion of the installation.

Installation Guide for the 2GIG EDGE Security Panel

Signal Strength

and

Connection Status

Power Status

Serial

will be

Table of Contents