Panel Programming - Built-In Zones - 2gig Technologies EDGE Installation Manual

Sensor Reports
1 . Highlight Sensor Reports.
2 . Choose Enabled or Disabled.
3 . Tap  to move to the next option.
Sensor Supervised
1 . Highlight Sensor Supervised.
2 . Under Sensor Supervised, choose Enabled or Disabled.
3 . Tap  to move to the next option.
Next Steps
The wireless zone is now programmed. Next, choose one of these options:
¾ To program the next wireless zone, tap Next Zone. Then, repeat the programming steps for the next zone.
¾ To erase all of the programmed settings for the wireless zone, tap Reset Zone.
¾ To go to the list of wireless zones, tap Back to Zones.
¾ Changes are saved instantly, so simply exit the toolbox to start using the new sensor/device.
P P – B
anel rogramming
You can program up to three (3) Built-In Zones per system (two Hard-wired zones and the Panel Glassbreak detector). To get started, navigate to
the . Tap Panel Programming, then tap the Built-In Zones option.
Installer Toolbox
Selecting a Wired Built-In Zone
1 . On the left side of the Built-In Zone screen, review the list of zones.
2 . Tap one of the available zones to highlight it. A zone is available when it
appears in gray text.
3 . Tap EDIT ZONE.
Sensor Type
1 . Highlight Sensor Type.
≡
2 . Tap to expand the list.
3 . Select the appropriate sensor type from the list.
For example: for a Door/Window Contact for a Patio Door,
perhaps select 03-Perimeter.
4 . Tap  to move to the next option.
Normal State
1 . Highlight Normal State.
2 . Choose one of these options:
¾ Normally Open (NO): Sends alert signal to the security system
when the sensor's circuit is no longer in the NO state.
¾ Normally Closed (NC): Sends alert signal to the security system
when the sensor's circuit is no longer in the NC state.
End-of-Line Resistor (EOL): Choose when an end- of-line (EOL)
resistor is present.
Installation Guide for the 2GIG EDGE Security Panel
-i Z
uilt n ones
30