Nine-Pin Graphics Modes - Intermec 6820 Series User Manual

—
Chapter 5 Control Code Definitions
90
Select Low-Speed Quadruple Density Graphics Mode
With this 8-pin graphics mode, the number of dots per inch has gone up
to 4x what it was in single density. Calculating the parameters, n1 and n2,
is described on page 88.
Format
Decimal
27 90 n1 n2
The resolution is now 240 dots per inch. Each 8-inch line can accommo-
date 1920 columns of graphic dots. A graphic string that exceeds the
length of the print line is discarded. Take care that adjacent dots in a given
dot row are not printed.

Nine-Pin Graphics Modes

These 9-pin graphics functions also require two parameters, n1 and n2.
However, they are calculated slightly different than in the 8-pin graphics
modes. Since each dot column to print must be represented by two data
bytes, the total length of the graphic string (following the Select ... Graphics
Mode command) needs to first be divided by two. These parameters are
calculated as follows (assuming a temporary variable n):
n = total number of dots needed, divided by 2
n2 = integer of (n divided by 256)
n1 = remainder of the n2 calculation
First, divide n (the total number of dots needed for the graphics string) by
2, then divide the result by 256. Then n2 is the quotient (the whole num-
ber) and n1 is the remainder. If you require less than 256 dots (columns),
then n1 indicates the number of dots and n2 is set to zero.
Select 9-Pin Single Density Graphics Mode
Single density, 9-pin graphics mode is enabled. Calculating the parameters,
n1 and n2, is described previously under Nine-Pin Graphics Modes.
Format
Decimal
27 94 0 n1 n2
The resolution is 60 dots per inch. Each 8-inch line can accommodate 480
columns of graphic dots. A graphic string that exceeds the length of the
print line is discarded.
Hex
1B 5A n1 n2
Hex
1B 5E 00 n1 n2
6820 Series 80-Column Printer User's Manual
ASCII
ESC "Z" n1 n2
ASCII
ESC "^" (0) n1 n2