Cancel Skip Over Perforation; Character Style And Text Mode Functions; Select Condensed Mode (Compressed); Cancel Condensed Mode (Compressed) - Intermec 6820 Series User Manual

—
Chapter 5 Control Code Definitions

Character Style and Text Mode Functions

72

Cancel Skip Over Perforation

The Skip Over Perforation is canceled, which allows the maximum number
of lines to be printed on each page.
Format
Decimal
27 79
The following set of functions affect the appearance of text on the printed
page. This could involve size, typeface, or other characteristics of the text.

Select Condensed Mode (compressed)

The condensed mode is selected, which prints characters at approximately
60% of the normal width. This results in character pitches, as shown be-
low (for exact pitch values, see Master Select, on page 75):
Condensed Mode
17 cpi (approximate)
This function empties the print buffer and turns compressed mode on, and
stays on until canceled by Cancel Compressed Mode, ESC SI (0) or DC2
(factory default = disabled). Note that this function is not supported in Dou-
ble-byte Character Sets (DBCS).
Format
Decimal
27 15
15

Cancel Condensed Mode (compressed)

This function cancels the compressed mode, enabled by Select Compressed
Mode, SI or ESC SI (1). Note that this function is not supported in DBCS.
Format
Decimal
27 18
18
Hex
1B 4F
Condensed + Expanded
9 cpi (approximate)
Hex
1B 0F
0F
Hex
1B 12
12
6820 Series 80-Column Printer User's Manual
ASCII
ESC "O"
Condensed + Elite
20 cpi (approximate)
ASCII
ESC SI
SI
ASCII
ESC DC2
DC2