Charging The Battery; Removing And Installing The Battery - Intermec CK3a1 User Manual

Chapter 1 — Using the Computer
Note: If the CK3 is not using external power and you remove the
battery pack, the CK3 goes into Suspend mode.
For replacement batteries, contact your Intermec representative.

Charging the Battery

Make sure you fully charge the AB17 or AB18 battery before you use
your CK3. You can charge the battery before or after you install it in
the CK3. A fully discharged battery charges in approximately 4 (AB17)
to 7 (AB18) hours.
To charge the battery
•
•
Use the next table to understand how long it takes to charge your
batteries in each of the CK3 charger or dock accessories.
Charging Times for CK3 Batteries
CK3 Charging Accessory
AC20 quad battery charger
AD20 single dock
AD21 ethernet multidock
AD22 charge-only multidock
AV10 vehicle dock

Removing and Installing the Battery

To maximize the time allowed to replace the main battery pack, put
the CK3 in suspend mode before removing the battery pack.
4
Insert the battery into the battery bay of the AD20 single dock, or
insert up to four batteries into the AC20 quad battery charger.
Or,
Install the battery in the CK3 and insert the CK3 into the AD20
single dock, AD21 ethernet multidock, AD22 charge-only
multidock, or AV10 vehicle dock.
AB17 Charging Time AB18 Charging Time
up to 4 hours up to 6 hours
up to 4 hours up to 6 to 7 hours
up to 4 hours up to 7 hours
up to 4 hours up to 7 hours
up to 4 hours up to 7 hours
CK3 Mobile Computer User's Manual