Display Operation - Endress+Hauser PROFIBUS Gammapilot M FMG60 Operating Instructions Manual
Radiometric measurement
Hide thumbs
Also See for PROFIBUS Gammapilot M FMG60:
- Operating instructions manual (118 pages) ,
- Brief operating instructions (60 pages) ,
- Safety instructions (36 pages)
Table of Contents
Advertisement
Operation
30
5.2
Display operation
5.2.1
Display and operating elements
The display and operating module VU331 is located in the remote display and operating unit
FHX40. The measured value can be read through the glass of the cover. In order to operate the
instrument, the FHX40 must be opened by removing the four screws.
Gammapilot M
Display and operating module VU331
Symbols
Display symbols
The following table describes the symbols that appear on the liquid crystal display:
Sybmol
Meaning
ALARM_SYMBOL
This alarm symbol appears when the instrument is in an alarm state. If the symbol flashes, this indicates a
warning.
LOCK_SYMBOL
This lock symbol appears when the instrument is locked,i.e. if no input is possible.
COM_SYMBOL
This communication symbol appears when a data transmission via e.g. HART, PROFIBUS PA or
FOUNDATION Fieldbus is in progress.
SIMULATION_SWITCH_ENABLE
This communication symbol appears when simulation in FOUNDATION Fieldbus is enabled via the DIP
switch.
Gammapilot M FMG 60 - PROFIBUS PA
FHX 40
ENDRESS + HAUSER
–
+
E
VU331
L00-FMG60xxx-19-00-00-xx-001
3 keys
L00-FMG60xxx-07-00-00-en-003
Advertisement
Table of Contents
