Removing/Attaching The Seating Shell/Seating Solution; Seating Solutions With Parallel Adapter - Otto Bock Dino 3 Instructions For Use Manual

2) Activate and hold the release lever (see fig. 15, item 1).
→ The locking mechanism is released.
3) Bring the back support frame to the desired angle by moving the push handles/push bar (see fig. 14).
4) Let go of the release lever.
→ The back support frame is secured at the desired angle.
14

7.3.5 Removing/attaching the seating shell/seating solution

WARNING
Improper handling of the seating unit
Tipping over, falling of the user due to failure to observe the installation instructions
► Check that the seat and the mobility base are securely connected every time the seating unit is mounted. The
seating unit must engage securely on the adapters.
► Do not exceed the maximum load capacity (see the section "Technical data").
INFORMATION
When removing/attaching the seating shell/seating solution, observe the instructions for use and safety notices
from the manufacturer of these products.

7.3.5.1 Seating solutions with parallel adapter

Seating solutions with a parallel seating shell interface can be attached to or removed from the parallel adapter in
just a few steps:
Detaching the seating unit
1) Activate the wheel locks on both sides of the mobility base for seating shells (see Page 25).
2) Stand next to the seating unit and hold the seat by the back support with one hand.
3) Pull the handle of the retaining claw under the seat up to the edge of the seat (see fig. 16, item 1).
→ The retaining claw will now release the seat adapter.
4) Tip the seat back at an angle of approx. 45° and then lift it up and out.
Mounting the seating unit
1) Activate the wheel locks on both sides of the mobility base for seating shells (see Page 25).
2) First place the seating unit on the rear tube of the seat adapter at an angle of approximately 45° (see fig. 16).
3) Press the front edge of the seat onto the mobility base until the retaining claw audibly snaps onto the front tube
of the seat adapter.
4) Check that the seat and the mobility base are securely connected. You can do this, for example, by pulling
back the back support.
Dino 3
15
Use
21