Liability; Warranty; Privacy Notice; Service Life - Otto Bock C1000 DS Instructions For Use Manual

11.1 Liability

The manufacturer will only assume liability if the product is used in accordance with the descriptions and instruc­
tions provided in this document. The manufacturer will not assume liability for damage caused by disregarding the
information in this document, particularly due to improper use or unauthorised modification of the product.

11.2 Warranty

Further information on the warranty terms and conditions can be obtained from the qualified personnel that has fit­
ted this product or the manufacturer's service (see inside back cover for addresses).

11.3 Privacy notice

Some components of the product contain data storage modules that temporarily or permanently store data. These
data are exclusively of a technical nature and serve the safety of the user, the identification and elimination of errors
and/or optimising the functionality of the product.
Depending on the model and version, malfunctions and faults of components relevant for safety as well as status
messages of individual components are recorded. The data are available in anonymised/pseudonymised form
when the data storage modules are read in case of service. Ottobock stores, processes and uses the data accord­
ing to the applicable data protection regulations.
For detailed questions please contact: datenschutz@ottobock.de. For questions regarding treatment, please con­
tact the qualified personnel.

11.4 Service life

Expected lifetime: 5 years
The design, manufacturing and requirements for the intended use of the product are based on the expected life­
time. These also include the requirements for maintenance, ensuring effectiveness and the safety of the product.

12 Technical data

INFORMATION
► Much of the technical data below is given in mm. Please note that product settings – unless otherwise spe­
cified – cannot be adjusted in the mm range but only in increments of approx. 0.5 cm or 1 cm.
► Note that the values achieved during adjustment may deviate from the values specified below. The deviation
can be ±10 mm and ±2°.
General information
Application class (in compliance with DIN
EN 12184)
Dimensions and weights
Seat depth
Seat width
Seat height
Lower leg length
Dimensions and weights
Angle of the seat surface
Angle of leg to seat
Distance from arm support to seat
Front position of the arm supports
Arm support height
Arm support length
Back support height (standard seat)
Back support angle
Back support angle adjustment
Seat inclination
Seat height adjustment
Seat tilt
C1000 DS
Class C
Standard seat
380 – 500 mm
380 – 560 mm
400/450/500/550 mm approx.
250 – 540 mm
0° – 6°
90° – 170°
225 – 325 mm
300 – 580 mm
225 – 350 mm
260 mm
450/500/550 mm
Manually, in 10° increments: -9°/1°/11°/21° or 0°/10°/20°/30°
Power: adjustable by up to 30° (depending on the seat depth)
0°/3°/6°
+ 300 mm or +400 mm (depending on version)
Power: adjustable by up to 30°/45° (depending on the version)
Contoured seat
360 – 480 mm
380 – 560 mm
520 mm;
approx. 570 mm
280 – 540 mm
Technical data
®
Recaro seat*
380 – 560 mm
450 – 480 mm
approx. 520 mm;
approx. 570 mm
75