Otto Bock Genium X3 Instructions For Use Manual page 32

Preparing the product for use
INFORMATION
Always use screws of similar type on the same flexion stop
When installing the screws, make sure that screws of similar type are always used on the same flexion stop.
Using a cap screw and a countersunk screw together to install the flexion stop is not permitted.
32
Removing the flexion stop
1) Use an appropriate screwdriver to loosen the screws on the flexion stop (left and
right of the piston rod).
2) Use the screwdriver to take the flexion stop out of the joint.
INFORMATION: Do not insert the screws without the flexion stop!
Inserting the flexion stop
1) Insert the flexion stop.
2) Secure the screws with 636K13 thread lock.
3) Insert the screws.
4) Tighten the screws to 0.6 Nm with the 710D17 torque wrench.
Genium X3 - Bionic Prosthetic System 3B5-X3/3B5-X3=ST,Ge­
nium X3 3B5-2/3B5-2=ST