Information On The Power Supply/Battery Charging - Otto Bock Genium X3 Instructions For Use Manual

Safety
CAUTION
Use of the product without protector or with damaged protector
> Falling due to unexpected product behaviour as the result of malfunction.
> Falling due to breakage of load-bearing components.
► If the protector has been removed, ensure prior to the next use of the product that the protector has been
properly installed.
► Using the product with a damaged protector or without the protector is not permitted.
► Using the product with a foam cover is not possible, since the protector would have to be removed for this
purpose.
CAUTION
Mechanical stress during transport
> Falling due to unexpected product behaviour as a result of a malfunction.
> Falling due to breakage of load-bearing components.
> Skin irritation due to defects on the hydraulic unit with leakage of liquid.
► Only use the transport packaging for transportation.
CAUTION
Signs of wear and tear on the product components
Falling due to damage or malfunction of the product.
► Regular service inspections (maintenance) are mandatory in the interest of patient safety and in order to main­
tain operating reliability and protect the warranty.
NOTICE
Improper product care
Damage to the product due to the use of incorrect cleaning agents.
► Clean the product with a damp cloth only (fresh water).
► Only use fresh water with a temperature of no more than 65°C for cleaning.
► If dirt cannot be removed, the product has to be sent to an authorised Ottobock Service Centre.
INFORMATION
Knee joint movement noise
When using exoprosthetic knee joints, servomotor, hydraulic, pneumatic or brake load dependent control func­
tions can cause movement noise. This kind of noise is normal and unavoidable. It generally does not indicate any
problems. If movement noise increases noticeably during the lifecycle of the knee joint, the knee joint should be
inspected by an authorised Ottobock Service Centre immediately.

4.4 Information on the Power Supply/Battery Charging

CAUTION
Charging the product without taking it off
Falling due to unexpected product behaviour because of changed damping behaviour.
► Instruct the patient that the product must be taken off before it is charged.
CAUTION
Charging the product with damaged power supply unit/charger/charger cable
Falling due to unexpected behaviour of the product caused by insufficient charging.
► Check the power supply unit, charger and charger cable for damage before use.
► Replace any damaged power supply unit, charger or charger cable.
18 Genium X3 - Bionic Prosthetic System 3B5-X3/3B5-X3=ST,Ge­
nium X3 3B5-2/3B5-2=ST