Figure 2-1 Serial Port Location - Sun Microsystems StorEdge T3 Service Manual

To start a serial connection and session with the array:
1. Connect a serial cable from the serial port on the array master unit to any host
system available serial port.
Note – The serial cables used by the Sun StorEdge T3 and T3+ arrays are different.
Both cables are supplied in the F370-4119-02 Diagnostic Kit. The T3 array uses the
serial cable with RJ-11 connectors and the T3+ array uses the serial cable with RJ-45
connectors.
The serial port on the array is on the controller card backplane.
FIGURE 2-1
2. On the host system, open a terminal window, type tip, the baud rate, and the
serial port designation.
For example:
mymachine# tip -9600 /dev/ttya
connected
Password:
Invalid name.
Login:root
Password:
T300 Release 1.13 2000/05/17 16:15:41 (129.150.47.104)
Copyright (C) 1997-2000 Sun Microsystems, Inc.
All Rights Reserved.
name:/:<1>
2-2 Sun StorEdge T3 and T3+ Array Field Service Manual • September 2001
Serial Port Location
Serial port