Preparation; Unpacking The Product; Inspecting The Product; Setting Up The Product - Storz IMAGE1 S CONNECT Instructions For Use Manual

5 Preparation

5.1 Unpacking the product

1. Carefully remove the product and accessories from the packaging.
2. Check the delivery for missing items and any possible damage.
3. In the case of damage, hidden defects, and short deliveries, document their nature and
extent and contact the manufacturer or supplier immediately.
4. Keep packaging for further transport.

5.2 Inspecting the product

1. Check the product and the camera head or videoendoscope for external damage.
2. Ensure that the camera head cable or videoendoscope cable is not damaged or kinked.
3. Point the camera head or the videoendoscope toward an object to check the display
quality on the monitor.
4. When using 3D videoendoscopes, check to make sure the monitor's display is correct.
5. Be sure to use the correct polarized eyewear for the monitor.

5.3 Setting up the product

WARNING
Blocked air inlets and air outlets! Risk of fire!
If the air inlets and outlets are blocked, the product may overheat. This can cause the product
to fail and start a fire. Users, patients, and third parties may be injured.
Remove any blockages in the air inlets and outlets when setting up the product.
1. Set the product down on a horizontal, flat surface or in a video cart. Make sure that the
power cord can be unplugged at any time.
2. Ensure adequate air circulation.
3. For best thermal performance, position the product at the top of the device stack.

5.4 Connecting the product

1. Connect the potential equalization cable.
Instructions for use • IMAGE1 S • 705LZA_EN_V2.1_05-2022_IFU_FDA
Preparation
24