Live Menu - Storz IMAGE1 S CONNECT Instructions For Use Manual

10. Tap the Memory/Eject button to eject the USB storage device. Data may be lost if the
USB storage device is not ejected.
ð The USB storage device can be removed.
11. Tap the Presets button.
12. If presets have been defined in the Setup menu, select a preset.
13. Tap the Setup button to open the Setup menu. Alternatively, you can press the
SHIFT+ENTER keys.
14. Tap the Info button to see contact information.
15. Tap the Patient button.
16. Create, select, modify, or delete a patient information record. Up to 50 patient
information records can be created.

6.2 Live menu

Using an electrosurgical unit in ICG color light mode can cause image distortion.
The Live menu allows you to choose between different camera functions and change the
settings of connected devices. Unconnected devices are shown in gray.
The Live menu can be opened using the following keys/buttons:
– The Enter key on the keyboard.
– The menu button on the camera head or videoendoscope.
– The left side button on the IMAGE1 PILOT.
Be sure not to touch the 3D wheel or the buttons while the IMAGE1 PILOT is connecting
to the IMAGE1 CONNECT.
1. Tap the Brightness button to set the brightness of the LINK module.
2. Tab the Print button to immediately print all images in the print queue.
ð Printouts with patient data remain in the queue until sufficient ink and paper are
available.
3. Switch the IMAGE1 S off and back on again to clear the queue.
Instructions for use • IMAGE1 S • 705LZA_EN_V2.1_05-2022_IFU_FDA
Application
31