Display (Live Menu) - Storz IMAGE1 S CONNECT Instructions For Use Manual

6.2.3 Display (Live menu)

Tap the Display button in the Live menu.
1.
2. Select one of the 4 display modes for the TIPCAM1 Rubina in Display Mode:
– 2D: 2D image without horizon control
– 2D Autorotation: 2D image with digital horizon control
– 3D: 3D image without horizon control
– 3D/2D Autoswitch: Automatic switch between 3D image and upright 2D image,
depending on the rotation angle of the TIPCAM1 Rubina. The angle for the image switch
can be adjusted.
3. If the position of the horizon indicator is incorrect, tap the Reset Orientation button to
restore the correct position.
In Adjust Horizon, tap the Plus or Minus button to rotate the digital image by the set
4.
angle.
5. Tap the OK button in Reset Horizon to 0 to reset the horizon.
6. Open the Primary Source drop-down menu and select a LINK module.
ð If the secondary source is configured with None or S-Technologies, the IMAGE1 S
automatically recognizes the module to which a camera head is connected, even if the
LINK used is not the primary source.
7. Open the Secondary Source (PiP) drop-down menu and select another LINK module or
an S-Technology.
8. In PIP Layout, select a layout to adapt the picture-in-picture (PiP) function display.
ð If S-Technology is selected and a visualization mode (CLARA or CHROMA) is selected,
the standard white light image and the applicable visualization mode are are displayed
next to one another as PiP.
ð If a D3-LINK or 4U-LINK is selected as the primary source and 3D equipment is
connected, the secondary source is deactivated.
9. Activate the Grid option to fade a grid into the camera image.
10. Set the grid transparency in Grid Visibility.
Instructions for use • IMAGE1 S • 705LZA_EN_V2.1_05-2022_IFU_FDA
Application
35