Possible Combinations; Installation Overview Of Image1 S Connect - Storz IMAGE1 S CONNECT Instructions For Use Manual

Power input
IMAGE1 S CONNECT
IMAGE1 S CONNECT II
IMAGE1 S H3-LINK
IMAGE1 S X-LINK
IMAGE1 S D3-LINK
IMAGE1 S 4U-LINK

4.4 Possible combinations

It is recommended that the suitability of the products for the intended procedure be checked
prior to use. Please note that the products listed here may not yet be available in all countries
due to differences in approval requirements.
The IMAGE1 S camera control unit (CCU) consists of the IMAGE1 S CONNECT (TC200US) or
IMAGE1 S CONNECT II (TC201US) and 1–3 additional LINK modules. The various modules
serve as interfaces to camera heads and videoendoscopes.
The following LINK modules are available:
– IMAGE1 S H3-LINK (TC300US)
– IMAGE1 S X-LINK (TC301US)
– IMAGE1 S D3-LINK module (TC302US)
– IMAGE1 S 4U-LINK module (TC304US)
Only compatible products may be combined with the CONNECT modules and LINK
modules, see chapter Accessories [p. 48].
KARL STORZ recommends combining only CONNECT modules and LINK modules with
the same software version.
The following products are required for navigation and input:
– Keyboard
– Mouse
The following products are available as options for navigation:
– Compatible camera heads and videoendoscopes
– IMAGE1 PILOT (TC014)
– Microscope footswitch (TC019)
Do not connect network devices (Ethernet, Bluetooth, or WiFi dongles) to the USB port of the
IMAGE1 S. The connection may impair operation of the IMAGE1 S.

4.4.1 Installation overview of IMAGE1 S CONNECT

If multiple KS HIVE-compatible peripheral devices are used, the OR1 HIVE router is
required.
Instructions for use • IMAGE1 S • 705LZA_EN_V2.1_05-2022_IFU_FDA
Product description
Value
62 VA
100–135 VA
80 VA
80 VA
80 VA
86 VA
16