Display (Setup Menu) - Storz IMAGE1 S CONNECT Instructions For Use Manual

32. Tap the Software Licenses button to view a list of the open source software included in
the product, and the open source software license terms.

6.3.1 Display (Setup menu)

Tap the Display button in the Setup menu.
1.
ð The following menu appears:
2. In PIP Layout, select a layout to adapt the picture-in-picture (PiP) function display.
Open the Primary Source drop-down menu and select a LINK module.
3.
ð If the secondary source is configured with None or S-Technologies, the IMAGE1 S
automatically recognizes the module to which a camera head is connected, even if the
LINK module used is not the primary source.
4. If the IMAGE1 S CONNECT (TC200US) is being used, select one of the following modes
for emitting the 3D signal:
– DVI 1
– DVI 1 / DVI 2
– DVI 1 / 3G-SDI
– DVI 1, DVI 2 / 3G-SDI
All outputs that are not selected transmit a 2D image. The 3D signal is always present at the
DVI 1 (see label on the IMAGE1 S CONNECT (TC200US)).
5. If the IMAGE1 S CONNECT II (TC201US) is used with connected D3-LINK, 4U-LINK, and
3D equipment, select outputs DP-1, DP-2/DVI, and SDI as 2D or 3D mode.
6. Open the SDI Output Resolution drop-down menu and select the resolution of the signal
outputs (available only with IMAGE1 S CONNECT II (TC201US)).
7. Open the Secondary Source (PiP) drop-down menu and select another LINK module or
an S-Technology.
ð If S-Technology is selected and a visualization mode (CLARA, CHROMA) is selected,
the standard white light image and the applicable visualization mode are are displayed
next to one another as PiP.
ð If a D3-LINK or 4U-LINK is selected as the primary source and 3D equipment is
connected, the secondary source is deactivated.
In User Interface Aspect Ratio, select Widescreen (16:9) or 4:3.
8.
Instructions for use • IMAGE1 S • 705LZA_EN_V2.1_05-2022_IFU_FDA
Application
39