5.4.5 Opening the Driveshield: Export Header
Follow these steps to open the driveshield on export header:
1. Release rubber latches (A).
2. Insert a screwdriver (or equivalent) through hole
in shield (B) and into the notch in latch (C) and
disengage latch.
3. Open shield (D).
5.4.6 Closing the Driveshield: Export Header
Follow these steps to close the driveshield on export header:
1. Lower the shield (C) so that pins at lower end of
shield engage holes in the lower panel and latch (B)
reengages shield.
2. Engage rubber latches (A).
169457
OPERATION
Figure 5.9
Figure 5.10
30
Rev. F