3.4.3 Opening the Driveshield: Export Headers
Follow these steps to open the driveshield on export headers:
1. Release rubber latches (A).
2. Insert a screwdriver (or equivalent) through hole
in shield (B) and into the notch in latch (C) and
disengage latch.
3. Open driveshield (D).
3.4.4 Closing the Driveshield: Export Headers
Follow these steps to close the driveshield on export headers:
1. Lower the shield (C) so that pins at lower end of
shield engage holes in the lower panel, and latch (B)
re-engages the driveshield.
2. Engage rubber latches (A).
214014
OPERATION
Figure 3.7: Driveshield
Figure 3.8: Driveshield
31
Revision B