Sun Microsystems Fire V490 Setup And Rackmounting Manual page 58

5. Route the cables into the two fingers in the first section of the cable management
arm.
Be sure you leave enough slack to ensure an adequate bend radius for the cables.
6. Group the cables and insert the group into the large oval cutout, as shown in the
next figure.
Use the oval cutout in the center section to route a group of cables through the cable
management arm. Be sure you leave enough slack around the hinge to ensure an
adequate bend radius for the cables.
Note – Do not insert the cables into the other metal cutouts. Use those cutouts to
access and manipulate the cables.
7. Route the cables into the three fingers in the third section of the cable
management arm, as shown in the next figure.
8. Using the Velcro straps, secure the cords and cables to the first and center sections
of the cable management arm.
48 Sun Fire V490 Server Setup and Rackmounting Guide • August 2004