Sun Microsystems Fire V490 Setup And Rackmounting Manual page 53

5. Attach a strain relief tie-wrap to each AC power cord.
Use the strain relief to prevent accidental or inadvertent removal of an AC power
cord from its inlet. The strain relief is a plastic tie-wrap and pedestal that is inserted
into the back panel of the server. Use these reliefs to manage the power cords after
you have installed the cords into the AC inlets in the server.
To use a strain relief, press the tab to release the tie-wrap. Wrap the loose end of the
tie-wrap around the AC power cord and thread the tie-wrap through the opening in
the relief pedestal. Pull the end of the tie-wrap to tighten it.
Strain
PCI 5 PCI 5 PCI 4 PCI 4
relief 33 MHz 33 MHz
2 x 2 x
200-240V AC I nput 200-240V AC I nput
1
0
1
0
1
PCI 3 PCI 3 PCI 2 PCI 2 SC PCI 1 PCI 1 PCI 0 PCI 0
(10 / 100 / 1000)
33 MHz 33 MHz 66 MHz 66 MHz
0
SERIAL
AC 1 AC 1
LBL: 263-1258-02
PS 1 PS 1
LBL: 263-1867-02 LBL: 263-1867-02
LBL: 263-1866-02
2 x 2 x
200-240V AC I nput
PS 0
Chapter 3 Setup Procedures
Strain
relief
43