Setup Procedures - Sun Microsystems Fire V490 Setup And Rackmounting Manual

3
C H A P T E R

Setup Procedures

This chapter tells you how to install the cable management arm, connect the power
cords and an Ethernet cable, and secure the cords and cables to the cable
management arm.
When you have completed the procedures in this chapter, you are ready to set up
a system console, power on the server, install the Solaris Operating System, and
install the electronic documentation. See the Sun Fire V490 Server Quick Start Guide
or the Sun Fire V490 Server Administration Guide for information about these
procedures.
Make sure that you have installed the Sun Fire V490 server into a 4-post cabinet or
2-post rack (see Chapters 1 and 2) before following the instructions in this chapter.
This chapter contains the following procedures and information:
"Inventory for Setup Procedures" on page 32
I
"Install the Cable Management Arm" on page 33
I
"Connect the Power Cords" on page 41
I
"Connect a Twisted-Pair Ethernet Cable" on page 44
I
"Secure the Cables to the Cable Management Arm" on page 46
I
"Restore the Cabinet" on page 50
I
31